z Search
z

Search our Store

z
Commonly searched:
z

LONG GUN SAFES

HANDGUN SAFES

GUN CABINETS

VAULT DOORS

MADE IN USA SAFES

z

CALL OUR SAFE EXPERTS AT 800-827-7534

AMERICAN SECURITY

LIBERTY SAFE

STEALTH SAFES

FORT KNOX

RHINO METALS





ALL BRANDS
z

CALL OUR SAFE EXPERTS AT 800-827-7534

HOME & OFFICE SAFES

DEPOSITORY SAFES

WALL SAFES

FLOOR SAFES

HIGH SECURITY

z

CALL OUR SAFE EXPERTS AT 800-827-7534

HOLSTERS & GUN SOCKS

DOOR ORGANIZERS

SAFE COVERS & CLOAKS

SAFE LIGHT KITS

DEHUMIDIFIERS

z

CALL OUR SAFE EXPERTS AT 800-827-7534

NL Lock Instructions & Videos


EL-30 & EL-25 Lock Instructions



Watch Video Instructions




Written Out Instructions Below:

STEP 1: Installing a Battery

Use a brand new Duracell Coppertop 9-Volt Battery expiring at least 5 years in the future.

WHY THIS BATTERYBecause this battery has the highest amperage output that is needed to operate the safe lock and open the door of the safe.

  • The battery compartment is located on the bottom side of the keypad
  • Simply slide open the compartment door and pull out the battery connector
  • Hook up a Duracell Coppertop 9-Volt battery to the battery connector with the + and - lined up
  • Push the connected battery back up into the compartment & slide the door shut

STEP 2: Changing the Default Code to your own Personal 6-Digit Code

NOTE:The following instructions are for changing the combination for the first time from the set default combination (1-2-3-4-5-6).Before you start this process make sure you know the 6-digit code you will set your safe to so the lock doesn't time out while you are setting your code.

  • Enter default code to unlock the safe: 1-2-3-4-5-6
  • Open the door and extend the bolts
  • Press and HOLD [0] on keypad until double beep. (LED light will remain on during next steps)
  • Enter DEFAULT code: 1-2-3-4-5-6 [double beep]
  • Enter NEW personalized 6-digit code [double beep]
  • Re-Enter NEW personalized 6-digit code [double beep]
  • Your new code has been successfully set

IMPORTANT: Make sure you test your new code several times with the door open before closing the safe to ensure your new code was set properly.


Replacing an Existing 6-Digit User Code:

  • Enter existing 6-digit user code to unlock the safe
  • Open the door and extend the bolts
  • Press and HOLD [0] on keypad until double beep. (LED light will remain on during next steps)
  • Enter existing 6-digit user code
  • Enter NEW 6-digit user code [double beep]
  • Re-Enter NEW 6-digit user code [double beep]
  • Your new code has been successfully set

IMPORTANT: Test new code several times before closing the door


TROUBLESHOOTING

  • LOW BATTERY: A series of beeps indicate that the battery is weak and must be replaced.
  • LOCKOUT MODE: If the wrong code is entered 4 times in a row, the lock will go into lockout mode - where it will constantly beep and flash for 5 minutes. Simply wait 5 minutes until the beeping/flashing stop and try again.NOTE: Removing the battery will only pause this 5 minute timer. The battery must be connect the whole 5 minutes.